View Single Post
  #6  
Old September 14th, 2007, 06:57 AM posted to microsoft.public.word.tables
Doug Robbins - Word MVP
external usenet poster
 
Posts: 8,239
Default Table Header Row doesn't repeat

On the Table tab of the Table Properties dialog, make sure that Text
wrapping is set to None in the bottom half of the dialog.

--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

"Sue D" wrote in message
...
I revealed hidden formatting codes and looked through three times for
section
or page breaks and did not see any. Table Properties shows only row 1 as
the
header row. I'm not sure what you mean by not wrapped. If you mean the
table is wider than the paper, I changed Table Properties to set the table
width at 100% and still have the problem.

"Doug Robbins - Word MVP" wrote:

The following has previously been posted when that problem has come up:

Make sure the table is not wrapped and has no breaks and that you don't
have
all the rows set as heading rows.


--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

"Sue D" wrote in message
...
I have a table with row 1 defined as a repeating header row. Table
Properties confirms the setting. However, the row does not repeat on
any
page. I cannot find a manual page break in the table. I have run a
repair
of the software. This table is 16 pages long so a header row is
desired.