Thanks. Where is there some sort of primer re trusted/untrusted XML?
I'm not familiar with this concept.
--
Mark Tangard, Microsoft Word MVP
"Life is nothing if you're not obsessed." --John Waters
Mark Nelson [MS] wrote:
Yes, it is one method of cleaning out bad bits. Using "untrusted" XML in
Visio causes a total recalc of the shapesheet. This is great for rebuilding
files but load time for the file is slower than binary or trusted XML.
-- Mark Nelson Microsoft Corporation This posting is provided "AS IS"
with no warranties, and confers no rights. "Mark Tangard"
wrote in message
...
Mark,
Wow. This worked!! I confess I have absolutely NO CLUE what saving as
XML actually *does*, but it sure banished the evil spirits. Is this
essentially a way to "decompose" a drawing & then reassemble its freshly
aired-out components?
Thanks very much.
--
Mark Tangard, Microsoft Word MVP
"Life is nothing if you're not obsessed." --John Waters
Mark Nelson [MS] wrote:
Very strange. You might try round-tripping the file through XML
to see
if
it can clean itself up. Save the document as VDX. Then open the
file
in
Notepad or another editor. Make some harmless change like adding a
space
and deleting it again, then resave the file. Now reopen the file in
Visio.
-- Mark Nelson Microsoft Corporation This posting is provided "AS IS"
with no warranties, and confers no rights.
"Mark Tangard" wrote in message
...
I'd been try to set it through the Text dialog. With the Shapesheet
it
also fails, but with different error language: "An Error (1)
occurred
during the action Set Formula or Name. Unexpected end of file."
Curious....
--
Mark Tangard, Microsoft Word MVP
"Life is nothing if you're not obsessed." --John Waters
Mark Nelson [MS] wrote:
Are you setting the margin through the Text dialog or via the
Shapesheet?
Does the other way also cause the same problem?
-- Mark Nelson Microsoft Corporation This posting is provided
"AS IS"
with no warranties, and confers no rights. "Mark Tangard"
wrote in message
...
On a flowchart I have, if I try to change the Top Margin
spec for
a
given (or several) Text Block(s), I get a message citing Error
3400,
Action 1642, and suggesting I close & reopen.
Closing/reopening has no effect. I can't change the top margin
on any
of the shapes. There's nothing unusual about the diagram. It's
got 7
shapes (all the same style), 6 connectors (ditto). One of the
shapes
is
pretty full and I've done a fair amount of paragraph-space
adjusting
to
fit all the text. The file was created just recently (and so
was the
template on which it's based). Other files allow this operation
without
problems.
Any ideas how to fix this? Visio 2003, WinXP.
Thanks,
--
Mark Tangard, Microsoft Word MVP
"Life is nothing if you're not obsessed." --John Waters
|