I believe this creates a Vertex Point and not a Bend Point.

I cannot find a way to create additional bend points once a line is drawn.
If you delete one you cannot put it back unless the Edit - Undo is still
holding it.



"Novice" wrote:

Hi there,

Ive been wondering how to do this for years, and found it!

Thought i'd help out even though its 11months later. You use the pencil
tool, whilst holding down the Ctrl key.

From this article: "Reshape an arc"
http://office.microsoft.com/en-us/vi...503351033.aspx

Alex





"Evan P. Daily" wrote:

Your're right, I didn't want to hear that. But that's the way it is with the
truth sometimes. Thanks for breaking it to me gently, and thanks for your
help.

"Don Visio" wrote:

More than one bend point in a line denotes that the freeform tool was used, &
as such, no, you cann't add "bend points."

Sorry, I doubt that's what you wanted to hear.
--
CWalton
VisioRenderer, MD
Architectural & Construction Documentation


"Evan P. Daily" wrote:

Thanks for the help, but I misspoke. I am working with the curved
connectors, not lines. My bad. Can I add bend points to curved connectors?

"Don Visio" wrote:

A drawn line segment has two endpoints with a radius control point between.
These three points will only be seen when using the straight line, curve,
arc, & freeform tools. With the line selected, hold down control & left click
at the point on the line where you want to add a line segment connector. For
each line segment connector you add, you will add a radius control handle.
You can only add line segment connectors. You cannot add radius control
handles.
--
CWalton
VisioRenderer, MD
Architectural & Construction Documentation


"Evan P. Daily" wrote:

I have several lines that need more bend points than were created when I
first added the line. I can select and delete the existing bend points, but
I have not found a way to add them.