View Single Post
  #9  
Old February 4th, 2009, 08:54 PM posted to microsoft.public.word.tables
Doug Robbins - Word MVP
external usenet poster
 
Posts: 8,239
Default Table Header Row doesn't repeat

Send me the document and I will take a look at it for you.

--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

"easbrown" wrote in message
...
I have tried all these things and still doesn't work. Using Word 2002.

"Sue D" wrote:

That was the problem!! I selected None and my headings appeared. Thank
you.

"Doug Robbins - Word MVP" wrote:

On the Table tab of the Table Properties dialog, make sure that Text
wrapping is set to None in the bottom half of the dialog.

--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

"Sue D" wrote in message
...
I revealed hidden formatting codes and looked through three times for
section
or page breaks and did not see any. Table Properties shows only row
1 as
the
header row. I'm not sure what you mean by not wrapped. If you mean
the
table is wider than the paper, I changed Table Properties to set the
table
width at 100% and still have the problem.

"Doug Robbins - Word MVP" wrote:

The following has previously been posted when that problem has come
up:

Make sure the table is not wrapped and has no breaks and that you
don't
have
all the rows set as heading rows.


--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of
my
services on a paid consulting basis.

Doug Robbins - Word MVP

"Sue D" wrote in message
...
I have a table with row 1 defined as a repeating header row.
Table
Properties confirms the setting. However, the row does not repeat
on
any
page. I cannot find a manual page break in the table. I have run
a
repair
of the software. This table is 16 pages long so a header row is
desired.