If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gaps between detail in a report
I want a report that will print out like a table. I have created a simple
detail row with single control across the page and vertical lines between them. The detail is same height as the lines. But when I print out there are gaps between the vertical lines, ie between the lines of detail. How can I get continuous vertical lines down my report to separate controls into columns? -- Regards Sarah |
#2
|
|||
|
|||
Gaps between detail in a report
I have seen this on Stephen Lebans page at:
http://www.lebans.com/PrintLines.htm Hope it helps "Sarah" wrote: I want a report that will print out like a table. I have created a simple detail row with single control across the page and vertical lines between them. The detail is same height as the lines. But when I print out there are gaps between the vertical lines, ie between the lines of detail. How can I get continuous vertical lines down my report to separate controls into columns? -- Regards Sarah |
Thread Tools | |
Display Modes | |
|
|