If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Setting file association won't stick
Trying to associate Visio files (*.vss, *.vsd) to Visio 2003, but no go.
Visio is not on "open with" list - browse to Visio.exe and double-click or "Open" does nothing. How can I get it on the list? It seemed to happen after I had uninstalled Visio 2000 with which the *.vs* files were associated. Thanks Paddy |
#2
|
|||
|
|||
Setting file association won't stick
If you haven't already done so, I would suggest running a repair on your
Visio 2003 installation. Go to Add or Remove Programs in the Control Panel, select Visio 2003 in the list and click the Change button. Choose the Repair option on the next screen. -- Tim Davenport Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Paddy" wrote in message ... Trying to associate Visio files (*.vss, *.vsd) to Visio 2003, but no go. Visio is not on "open with" list - browse to Visio.exe and double-click or "Open" does nothing. How can I get it on the list? It seemed to happen after I had uninstalled Visio 2000 with which the *.vs* files were associated. Thanks Paddy |
#3
|
|||
|
|||
Setting file association won't stick
"Tim Davenport [MSFT]" wrote: If you haven't already done so, I would suggest running a repair on your Visio 2003 installation. Go to Add or Remove Programs in the Control Panel, select Visio 2003 in the list and click the Change button. Choose the Repair option on the next screen. -- Tim Davenport Microsoft Corporation "Paddy" wrote in message ... Trying to associate Visio files (*.vss, *.vsd) to Visio 2003, but no go. Visio is not on "open with" list - browse to Visio.exe and double-click or "Open" does nothing. How can I get it on the list? Ah! Thanks Tim. Didn't know that option was there. Paddy |
Thread Tools | |
Display Modes | |
|
|