#Name? in A2003

I just opened a 2002 project in Access 2003 and a calculated control is
giving me the #Name? error. The expression is:

=[Loads].[Form].[RecordsetClone].[RecordCount] & " Loads Selected"

Doesn't Acess 2003 allow reading the recordset clone of a subform?

God Bless,

Mark

Check out this recent post on the same subject ...

http://groups.google.com/group/micro...ecf211c9e9f29b

--
Brendan Reynolds (MVP)

"Mark A. Sam" wrote in message
...
I just opened a 2002 project in Access 2003 and a calculated control is
giving me the #Name? error. The expression is:

=[Loads].[Form].[RecordsetClone].[RecordCount] & " Loads Selected"

Doesn't Acess 2003 allow reading the recordset clone of a subform?

God Bless,

Mark

Thanks Brendon,

Are you suggesting writing a function? It is probably a better method than
the calculated field, becuase it doesn't capture the true count unless I
refresh after the recordset is loaded. I find it disturbing though that this
method no longer works. People can't understand why I criticize Microsoft.
It's these "many", little things which take up time.

God Bless,

Mark


"Brendan Reynolds" wrote in message
...
Check out this recent post on the same subject ...


http://groups.google.com/group/micro...ecf211c9e9f29b

--
Brendan Reynolds (MVP)

"Mark A. Sam" wrote in message
...
I just opened a 2002 project in Access 2003 and a calculated control is
giving me the #Name? error. The expression is:

=[Loads].[Form].[RecordsetClone].[RecordCount] & " Loads Selected"

Doesn't Acess 2003 allow reading the recordset clone of a subform?

God Bless,

Mark