![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
jw wrote:
...when I try to get the data series on the first axis to be an xy scatter, all the data lines up vertically on the y axis and the x axis labels change to nonsense. What are the ranges in your "Source Data" boxes? Where is your source data? Dave dvt at psu dot edu |
#2
|
|||
|
|||
![]()
Thans for your response! I have my data in four series,
three to be charted on the primary x-axis and one to be charted on the secondary x-axis. After a certain amount of experimenting, I found that I can select the one series to be charted on the secondary axis, then I must go to the Chart Options menu and select "Secondary X-axis" and deselect "Secondary Y-axis". The data charted correctly. I just had to follow it through a bit more! -----Original Message----- jw wrote: ...when I try to get the data series on the first axis to be an xy scatter, all the data lines up vertically on the y axis and the x axis labels change to nonsense. What are the ranges in your "Source Data" boxes? Where is your source data? Dave dvt at psu dot edu . |
#3
|
|||
|
|||
![]()
jw wrote:
Thans for your response! I have my data in four series, three to be charted on the primary x-axis and one to be charted on the secondary x-axis. After a certain amount of experimenting, I found that I can select the one series to be charted on the secondary axis, then I must go to the Chart Options menu and select "Secondary X-axis" and deselect "Secondary Y-axis". The data charted correctly. I just had to follow it through a bit more! Ahh yes. I would have needed quite a bit more info to detect that one! Good thing you found it yourself. Dave dvt at psu dot edu |
Thread Tools | |
Display Modes | |
|
|