|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 1st, 2008, 11:35 PM
posted to microsoft.public.access.forms
|
|||
|
|||
forms
Hi, I created a form using the wizard based on a query, everything looks ok
but i cannot enter data into the form because it is locked? what have i done wrong, i been trying to solve this for 2 hours now - please can you HELP!!! 
|
|
#2
March 2nd, 2008, 12:54 AM
posted to microsoft.public.access.forms
|
|||
|
|||
|
forms
Since you created the form via the wizard (and, I assume, you have not
subsequently changed any form properties), the most likely cause is that the underlying query itself is non-updateable. You can check this quickly by opening the query and seeing if there is a blank new record at the bottom. There are many reasons why a query may be non-updateable; see here for details: http://allenbrowne.com/ser-61.html HTH, Rob "blake7" wrote in message ... Hi, I created a form using the wizard based on a query, everything looks ok but i cannot enter data into the form because it is locked? what have i done wrong, i been trying to solve this for 2 hours now - please can you HELP!!!
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
