If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Macro to select last row
I am trying to automate putting a sheet value into Row I. My manual method
is to paste the formula in I2 (since values begin on Row 2), then go to A2, Ctrl Down until I hit the last record (there are cases where there are blanks so sometimes I need to do this a few times) and when I reach it tab back over to the same row in I and Ctrl-Shift Arrow Up and then Fill Down. Somehow this doesn't work very well when recorded as a macro, any suggestions appreciated. In my ideal world in fact once this script worked for a page I'd have a VBA script that would step through each page and apply the function and voila! |
Thread Tools | |
Display Modes | |
|
|