If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cursor not visible in table
I have a 2 column wide table that is in a 2 column word doc. One column of the table contains pictures and the other column contains text. It's 2 column because I want the table to be half the page width. There is only 1 table that continues on each subsequent page. When I'm on the 4rd page of the doc, I can see the cursor and add pictures and text. But if I go back to the 2nd page, the cursor is invisible. It was visible on that page when I first created it, but now it's not. I can still edit the content, but since I can't see the cursor, it's pretty dificult. I'm guessing it's a feature since I haven't seen this before and it's the first time I've put a table in a 2 column doc. Any ideas? -- ehamike |
#2
|
|||
|
|||
cursor not visible in table
It's not a feature; it's definitely a bug, known to occur when you have a
table in a multicolumn section. I believe I've read that the document is correctly editable in Draft view. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org "ehamike" wrote in message ... I have a 2 column wide table that is in a 2 column word doc. One column of the table contains pictures and the other column contains text. It's 2 column because I want the table to be half the page width. There is only 1 table that continues on each subsequent page. When I'm on the 4rd page of the doc, I can see the cursor and add pictures and text. But if I go back to the 2nd page, the cursor is invisible. It was visible on that page when I first created it, but now it's not. I can still edit the content, but since I can't see the cursor, it's pretty dificult. I'm guessing it's a feature since I haven't seen this before and it's the first time I've put a table in a 2 column doc. Any ideas? -- ehamike |
Thread Tools | |
Display Modes | |
|
|