If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Apply Command Button Special Effect
Am able to apply a special effect to a label, separate from, let's say,
command button. Thanks to previous response. Although, when in design view, click on a command button, the special effect button in design tools, becomes disabled. When I right click on the command button, and one of the options shown is special effect, that is also disabled. I remember in Access 2003, there was a 'special' spot to apply special effects. does anyone know the trick for 2007. Help is no help on the subject. Thanks ahead of time. -- Jeanne |
#2
|
|||
|
|||
Apply Command Button Special Effect
Hi Jeanne,
look on the Design tab on the ribbon. It is a small grey rectangle with a drop down arrow to the right. In the section for Controls, just to the left of an orange button called select and another one called Use Control Wizards. "Jeanne" wrote in message ... Am able to apply a special effect to a label, separate from, let's say, command button. Thanks to previous response. Although, when in design view, click on a command button, the special effect button in design tools, becomes disabled. When I right click on the command button, and one of the options shown is special effect, that is also disabled. I remember in Access 2003, there was a 'special' spot to apply special effects. does anyone know the trick for 2007. Help is no help on the subject. Thanks ahead of time. -- Jeanne |
Thread Tools | |
Display Modes | |
|
|