If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
How do I split a table over 2 pages?
See http://word.mvps.org/FAQs/TblsFldsFm...ksInTables.htm
-- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org "MM" wrote in message ... Hello Brian I know this is a while after the first post but I am having a similar problem and your suggestions didn't work for me. I have a table with varying number of columns at each row. My table needs to be longer than 1 page however it transplants to the second page except for the first row which stays at the top of the first page with empty space for the rest of the first page. the option to split the table is checked and I clicked that symbol and there is only one of them under the table that cannot be removed. "Brian" wrote: Glad I could help. -- Brian McCaffery "Natalie Tinson" wrote: Perfect thank you! I've spent all day trying to figure that out! Thank you Natalie "Brian" wrote: Click the ΒΆ symbol on the toolbar. Go to the bottom of the table. Do you have a series of the symbols running down the page. If so start from the first below the table and delete them leaving the last in place. Or do you have a section break or hard page break at the bottom of the table. If so delete this and see what happens. Post back with the results. -- Brian McCaffery "Natalie Tinson" wrote: I did this but now the table continues onto the next page as I wanted but everything from the next page gets shifted onto the one after - even though there is plenty of room for it. Do you know if this can be solved or is it just the version of Word I am using won't allow it? Thanks Natalie "Brian" wrote: In the table properties dialogue box, select the row tab and check the "Allow row to break across pages" check box. hope this helps, -- Brian McCaffery "Natalie Tinson" wrote: I'm using Microsoft Word and when I am inputing the information into the table, it just goes onto the next page and leaves a massive blank area on the previous page. Does anyone know how to split the table so it an just continue onto the next page without leaving massive blank areas? Thanks for your help |
|
Thread Tools | |
Display Modes | |
|
|