|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 16th, 2008, 06:30 AM
posted to microsoft.public.word.tables
|
|||
|
|||
Table Row Headings - not on every page
How do I get to have one half of a document with one Table Row Heading and
the other half of the same table in the same document to have a slightly altered Table Row Heading? Currently I am using "Heading Rows Repeat" however I cannot seem to change part of it without creating a completely new document. 
|
|
#2
July 16th, 2008, 06:36 AM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Table Row Headings - not on every page
Hi Laura,
You could simulate what you want by setting the document up to use different odd/even pages, then putting one table heading in the odd page header and the other table heading in the even page header. With careful formatting, you should be able to get both headings lined up with the tables beneath and minimise the inherent gap between the two. -- Cheers macropod [MVP - Microsoft Word] "Laura" wrote in message ... How do I get to have one half of a document with one Table Row Heading and the other half of the same table in the same document to have a slightly altered Table Row Heading? Currently I am using "Heading Rows Repeat" however I cannot seem to change part of it without creating a completely new document.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
