If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
setting up a 4.25 wide by 8.5 height paper
What would the dimensions be under Page Setup for Margins
and Paper to set up a document so that it will print with a left margin of 1.5 inches (so as not to print over the 3- hole punch)? |
#2
|
|||
|
|||
setting up a 4.25 wide by 8.5 height paper
Actually, the number you put into the Margins box is the margin, so....1.5.
DM "John Sullivan" wrote: What would the dimensions be under Page Setup for Margins and Paper to set up a document so that it will print with a left margin of 1.5 inches (so as not to print over the 3- hole punch)? |
#3
|
|||
|
|||
setting up a 4.25 wide by 8.5 height paper
For purposes of binding, use the "gutter" margin. Leave
the margins of the document itself be, and add a .5 (or more) gutter under File|Page setup| Margins. -----Original Message----- What would the dimensions be under Page Setup for Margins and Paper to set up a document so that it will print with a left margin of 1.5 inches (so as not to print over the 3- hole punch)? . |
Thread Tools | |
Display Modes | |
|
|