|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 11th, 2004, 04:57 PM
|
|||
|
|||
Resizing a Visio File
I have a 36 x 24 in doc I need to resize to letter or legal. In page setup
it resizes the paper but the objects remain. Can someone explain the steps to get the entire format to shrink? 
|
|
#2
October 21st, 2004, 01:05 AM
|
|||
|
|||
|
Try this:
After selecting "Letter", make sure "fit to one sheet(s) across by one sheet(s) down is checked on both the page setup and print setup dialog boxes and "No scale" for the drawing scale is checked. "Douglas" wrote: I have a 36 x 24 in doc I need to resize to letter or legal. In page setup it resizes the paper but the objects remain. Can someone explain the steps to get the entire format to shrink?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| You do not have exclusive access... ERROR | Robin | General Discussion | 1 | July 6th, 2004 01:18 AM |
| Application must be installed to run Error | Keith | Setup, Installing & Configuration | 1 | June 29th, 2004 03:02 AM |
| Unsafe Attachments | Ron | Installation & Setup | 2 | June 9th, 2004 01:55 AM |
| Product Key for Office XP | P.G.Indiana | Setup, Installing & Configuration | 1 | June 7th, 2004 03:22 AM |
| Visio 2000 - buffer overrun error | charlie | Visio | 1 | May 15th, 2004 03:19 AM |
Linear Mode
