If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Thanks for the feed-back.
-- Regards, RD --------------------------------------------------------------------------- Please keep all correspondence within the NewsGroup, so all may benefit ! --------------------------------------------------------------------------- "Tonya Marshall" wrote in message ... Ragdyer wrote: The formula you're using in column X should make this slight revision work in column Y: =IF(X3"",SUM($X$3:X3),"") Thank you, RD, so much. It's perfect. Tonya |
#22
|
|||
|
|||
Thank you everyone so much for all of the help. After all the questions
and answers I was able to construct a formula on my own with an IF statement for another column. Beginning to flap my wings just a little. Tonya Marshall |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rounding a result | Johnny Lunchbucket | General Discussion | 1 | July 27th, 2004 05:57 PM |
Can I make a formula that has the result of "0" remain empty? | DangerMouse114 | Worksheet Functions | 2 | May 12th, 2004 06:00 AM |
using & to concatenate result is yuck | Jamie | Worksheet Functions | 3 | April 9th, 2004 06:29 PM |
Readding Numerical value to ext | Hoang Han | Worksheet Functions | 2 | December 4th, 2003 05:37 PM |