|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 17th, 2004, 11:52 PM
|
|||
|
|||
Copy and paste controls
I've got rather a lot of controls on a form (Access 2000) and, since
it's all getting rather overcrowded I'm considering using tab pages. Is there any way I can cut and paste the controls I've already created onto new tab pages on the form and not have to recreate things like their names, tag properties and so forth? Steve 
|
|
#2
June 18th, 2004, 12:20 AM
|
|||
|
|||
|
Copy and paste controls
"Stephen Glynn" wrote in message
... I've got rather a lot of controls on a form (Access 2000) and, since it's all getting rather overcrowded I'm considering using tab pages. Is there any way I can cut and paste the controls I've already created onto new tab pages on the form and not have to recreate things like their names, tag properties and so forth? Steve Cut them, select the desired tab page, and then paste. All you should have to replace is the "[Event Procedure]" entry for all events you are using. The code will still be there, but the property setting will be lost. -- I don't check the Email account attached to this message. Send instead to... RBrandt at Hunter dot com
|
|
#3
June 18th, 2004, 12:55 AM
|
|||
|
|||
|
Copy and paste controls
Rick Brandt wrote:
"Stephen Glynn" wrote in message ... I've got rather a lot of controls on a form (Access 2000) and, since it's all getting rather overcrowded I'm considering using tab pages. Is there any way I can cut and paste the controls I've already created onto new tab pages on the form and not have to recreate things like their names, tag properties and so forth? Steve Cut them, select the desired tab page, and then paste. All you should have to replace is the "[Event Procedure]" entry for all events you are using. The code will still be there, but the property setting will be lost. Thanks. I'd tried before and, for some reason, it didn't seem to work. It has done this time, though (apart from the name, of course). Most Strange Steve
|
|
#4
June 18th, 2004, 01:44 AM
|
|||
|
|||
|
Copy and paste controls
"Stephen Glynn" wrote in message
... Rick Brandt wrote: Thanks. I'd tried before and, for some reason, it didn't seem to work. It has done this time, though (apart from the name, of course). If you Cut and Paste rather than Copy and Paste the names will not be affected. This would also be required to maintain any code. -- I don't check the Email account attached to this message. Send instead to... RBrandt at Hunter dot com
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
