If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to get page margins to accept change?
Copied mdb from access 2000 format to 2003 format but page margins will not
allow change. How can I get the page setup to allow changes in margins? |
#2
|
|||
|
|||
Al.Plunkett wrote:
Copied mdb from access 2000 format to 2003 format but page margins will not allow change. How can I get the page setup to allow changes in margins? The first thing to check is that you have the right printer set as the Windows Default Printer (you might need to select a different printer and then change it back). If you can not change the margins at all, it usually means you need to refresh/reinstall your printer driver. If the problem is that you can change them, but you can't make them as small as you could on the older system, it usually means you changed printers and the new printer doesn't allow margins that small. -- Marsh MVP [MS Access] |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FIrst page footers | Noel S Pamfree | General Discussion | 7 | December 6th, 2004 08:49 PM |
Extra detail format | Phil | Setting Up & Running Reports | 8 | November 10th, 2004 12:13 AM |
Changing Page Numbers | Wood | General Discussion | 1 | August 14th, 2004 05:54 AM |
can't set page margins | Ann L | Setting Up & Running Reports | 0 | July 14th, 2004 06:12 PM |
odd page section breaks | Bill Mitchell | Formatting Long Documents | 6 | June 17th, 2004 02:20 PM |