If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Exclusive Front End
I went into Tools, Options, Advanced and selected Exclusive. I thought that
by doing this, it would allow the front end to be opened once at a time. However, after doing this, I selected the front end, opened the program, and then minimized it. I then went and selected the very same front end and opened it again and I was able to do so. How can I stop/prevent this from happening? Thanks, |
#2
|
|||
|
|||
Exclusive Front End
See The Access Web article:
http://www.mvps.org/access/api/api0041.htm -- HTH Van T. Dinh MVP (Access) "Christy" wrote in message ... I went into Tools, Options, Advanced and selected Exclusive. I thought that by doing this, it would allow the front end to be opened once at a time. However, after doing this, I selected the front end, opened the program, and then minimized it. I then went and selected the very same front end and opened it again and I was able to do so. How can I stop/prevent this from happening? Thanks, |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to work on home laptop, then update client's Front End? | lorirobn | General Discussion | 3 | September 24th, 2005 05:59 AM |
Exclusive open mode | codeman | General Discussion | 1 | August 24th, 2005 02:53 PM |
Exclusive Open Mode for Databases | codeman | General Discussion | 0 | August 22nd, 2005 12:53 PM |
Front end/Back end | Jack MacDonald | New Users | 2 | August 3rd, 2005 01:24 AM |
single-sided front matter, double-sided body? | R Parker | Formatting Long Documents | 2 | November 12th, 2004 08:21 PM |