|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 29th, 2009, 06:39 PM
posted to microsoft.public.visio.general
|
|||
|
|||
Configuration File with Icon
Hi,
I create many network diagrams with visio and I would like to be able to have an option or the ability to double click the Switch, router, firewall, etc. icon and pull the config file for that specific icon. How might I do this with the least amount of complexity? Looking for a simple fix as I have many, many drawings I would like to do this with... thx 
|
|
#2
April 29th, 2009, 08:17 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Configuration File with Icon
a simple macro that calls the windows shell will do it, since firewalls are
involved you can have the macro open your ssh application so that you can telnet to it. The assumption is that the ip address of the resource is stored in shape data in the drawing. al "Jim" wrote in message ... Hi, I create many network diagrams with visio and I would like to be able to have an option or the ability to double click the Switch, router, firewall, etc. icon and pull the config file for that specific icon. How might I do this with the least amount of complexity? Looking for a simple fix as I have many, many drawings I would like to do this with... thx
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
