If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Form Size
I have a form that I imported from another project, (it works fine) All I
did was change the source so I could start changing things, but when I change to ‘form view’ the form opens to be about 1” sq. Is there something I forgot to do?? Thanks in advance Bill |
#2
|
|||
|
|||
Form Size
Open the form in design. set it to the size it should be, save the form again
en then open it again. Maybe that helps. -- Maurice Ausum "open a adobe file from a command button" wrote: I have a form that I imported from another project, (it works fine) All I did was change the source so I could start changing things, but when I change to ‘form view’ the form opens to be about 1” sq. Is there something I forgot to do?? Thanks in advance Bill |
Thread Tools | |
Display Modes | |
|
|