If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
design view colors
The box for details in design view is transparent so is the properties box in
design view in quiereies how do I change? |
#2
|
|||
|
|||
I scan old newsgroup postings that do not have responses, trying to
determine why no one bothered to react to your initial inquiry, dated 11/25/2004, titled "design view colors". Your posting might have been bypassed for one or more of the following reasons: (a) it is too vague, (b) it requires somewhat more than a simple, direct response, (c) you are looking for someone to devise a total solution to your problem, (d) your question will require extensive research, or (e) you are pushing the envelope of the general, technical knowledge of those who view the Newsgroup's postings. If your problem hasn't yet been resolved, you can try posting it again with new phrasing and one of us will take a fresh look at it. On your original posting, you should click the YES or NO buttons to close out that entry on the system. Steve in Ohio "dmaj5" wrote: The box for details in design view is transparent so is the properties box in design view in quiereies how do I change? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Design view input???? | Phil | Running & Setting Up Queries | 3 | October 31st, 2004 02:04 PM |
Access 97 form will only display in design view | Lee | Using Forms | 1 | September 29th, 2004 05:04 AM |
mail folder > modify view... modifications not remembered | kenjk04 | General Discussion | 1 | September 27th, 2004 09:00 PM |
Property of table in design view toolbar button? | Margaret Bartley | General Discussion | 0 | August 13th, 2004 10:25 PM |