If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
create a master shape
Hi,
i've created a master shape by including several lines, circles,... now i want that all these things grouped as only 1 shape. I tried to use "Group" after selecting all shapes, but after this 'grouping' i still can select 1 particular line or circle and move it in some other place within my sheet... How can i do to make all these things works as 1 single shape ? thanks a lot, Alain |
#2
|
|||
|
|||
create a master shape
On Thu, 10 Aug 2006 12:35:30 +0200, "Alain R."
wrote: Hi, i've created a master shape by including several lines, circles,... now i want that all these things grouped as only 1 shape. I tried to use "Group" after selecting all shapes, but after this 'grouping' i still can select 1 particular line or circle and move it in some other place within my sheet... How can i do to make all these things works as 1 single shape ? Select all the shapes and from the menu Format - Behavior in the group behavior section select Group only -- Regards, Paul Herber, Sandrila Ltd. http://www.pherber.com/ Electronics for Visio http://www.electronics.sandrila.co.uk/ |
#3
|
|||
|
|||
create a master shape
Thanks Paul... but it still does not work correctly :-(
i have 2 shapes : A and B. B is over A and B is inside A. if i enlarge A, B is enlarged also. However, if i click on B, i can enlarge B without enlarging A... Worse B can be larger than A. :-( I'm lost... Alain Paul Herber wrote: On Thu, 10 Aug 2006 12:35:30 +0200, "Alain R." wrote: Hi, i've created a master shape by including several lines, circles,... now i want that all these things grouped as only 1 shape. I tried to use "Group" after selecting all shapes, but after this 'grouping' i still can select 1 particular line or circle and move it in some other place within my sheet... How can i do to make all these things works as 1 single shape ? Select all the shapes and from the menu Format - Behavior in the group behavior section select Group only |
#4
|
|||
|
|||
create a master shape
I don't understand your configuration, but if you can still select shapes
within a group then the group shape probably did not get its selection behavior set to Group Only. -- Mark Nelson Office Graphics - Visio Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Alain R." wrote in message ... Thanks Paul... but it still does not work correctly :-( i have 2 shapes : A and B. B is over A and B is inside A. if i enlarge A, B is enlarged also. However, if i click on B, i can enlarge B without enlarging A... Worse B can be larger than A. :-( I'm lost... Alain Paul Herber wrote: On Thu, 10 Aug 2006 12:35:30 +0200, "Alain R." wrote: Hi, i've created a master shape by including several lines, circles,... now i want that all these things grouped as only 1 shape. I tried to use "Group" after selecting all shapes, but after this 'grouping' i still can select 1 particular line or circle and move it in some other place within my sheet... How can i do to make all these things works as 1 single shape ? Select all the shapes and from the menu Format - Behavior in the group behavior section select Group only |
Thread Tools | |
Display Modes | |
|
|