If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Form view
I created a form called Master Employee List. Whenever I open this form, it
immediatedly opens in datasheet view. How can I have it open in Form View as default? Thanks, Bob |
#2
|
|||
|
|||
Form view
Hi Bob76,
on the form's property dialog, on the format tab, look for the property called Default View. Change it to Single Form. Jeanette Cunningham MS Access MVP -- Melbourne Victoria Australia "Bob76" wrote in message ... I created a form called Master Employee List. Whenever I open this form, it immediatedly opens in datasheet view. How can I have it open in Form View as default? Thanks, Bob |
#3
|
|||
|
|||
Form view
Did it.....Thanks a lot, Jeanette....
"Jeanette Cunningham" wrote: Hi Bob76, on the form's property dialog, on the format tab, look for the property called Default View. Change it to Single Form. Jeanette Cunningham MS Access MVP -- Melbourne Victoria Australia "Bob76" wrote in message ... I created a form called Master Employee List. Whenever I open this form, it immediatedly opens in datasheet view. How can I have it open in Form View as default? Thanks, Bob |
#4
|
|||
|
|||
Form view
On Sat, 21 Mar 2009 00:01:01 -0700, Bob76 wrote:
Did it.....Thanks a lot, Jeanette.... "Jeanette Cunningham" wrote: Hi Bob76, on the form's property dialog, on the format tab, look for the property called Default View. Change it to Single Form. Jeanette Cunningham MS Access MVP -- Melbourne Victoria Australia "Bob76" wrote in message ... I created a form called Master Employee List. Whenever I open this form, it immediatedly opens in datasheet view. How can I have it open in Form View as default? Thanks, Bob Be aware that even though you have now set this form's Default View to Datasheet View, if you should everr open it using code you must specify Datasheet View, otherwise it will again open in Form View. DoCmd.OpenForm "FormName", acFormDS -- Fred Please respond only to this newsgroup. I do not reply to personal e-mail |
Thread Tools | |
Display Modes | |
|
|