|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 18th, 2008, 11:00 AM
posted to microsoft.public.access.tablesdbdesign
|
|||
|
|||
Create Pages and Drag fields into it - Access 2003
Hello -
I want to use Pages/tab in my Form. and I want to Drag into it an existing formated fields that i created in the form. I can't do this unless a drag then from Scratch from the field list. Is there any way that it possible to drag to a page existing fields ?? (The form is well formated and to format it again will take a while that I'm trying to save...) 10x -- Alu_GK 
|
|
#2
September 18th, 2008, 11:45 AM
posted to microsoft.public.access.tablesdbdesign
|
|||
|
|||
|
Create Pages and Drag fields into it - Access 2003
Hello -
I Found the solution in a different answer in the forum... The Issue is to 1. Cut the field to move into the tab control/Page 2. Select the Page/Tab 3. Paste the Control. 10x -- Alu_GK "Alu_GK" wrote: Hello - I want to use Pages/tab in my Form. and I want to Drag into it an existing formated fields that i created in the form. I can't do this unless a drag then from Scratch from the field list. Is there any way that it possible to drag to a page existing fields ?? (The form is well formated and to format it again will take a while that I'm trying to save...) 10x -- Alu_GK
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
