If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
i get message "not enough memory. close " MS Access 2003 SP3
Was having problems with corrupted database, so set up a new mdb from my last
good mdb and imported all the objects into the new data base. I've reset all the References in tools. Now I get "Not enough memory to perform operation. close unneeded programs" message, along with a module not found message. I have repeated this on two different workstations with same issues. |
Thread Tools | |
Display Modes | |
|
|