|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 27th, 2004, 04:07 AM
|
|||
|
|||
Controling page breaks
How do you control whether a page break can occur in the
middle of a detail section. I want to keep the page break from separating the detail's header, body, or footer. Thanks in advance! 
|
|
#2
May 27th, 2004, 12:59 PM
|
|||
|
|||
|
Controling page breaks
Keith:
Open the sorting and grouping dialog where you've established the grouping and set the Keep Together property for the group to "Whole Group". -- Steve Arbaugh ACG Soft http://ourworld.compuserve.com/homepages/attac-cg "Keith" wrote in message ... How do you control whether a page break can occur in the middle of a detail section. I want to keep the page break from separating the detail's header, body, or footer. Thanks in advance!
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
