If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PP 07 AutoShape tranperancy.
Using Power point 2007. How can I set the transparency for inserted AutoShape?
I have 3 circles that overlay on top of each other. I want the part that overlay them to be about 50% transparent. the transparency shows when they hover over each other but. it is solid when I stop or print it. I can do this in PP 03 but not 07 with pivoted edges. Thanks |
#2
|
|||
|
|||
PP 07 AutoShape tranperancy.
To set a shape's transparency, select the shape, then right-click and choose
Format Shape. On the Fill tab, there is a transparency slider. It will show up once you've selected a solid fill option. -- Echo [MS PPT MVP] http://www.echosvoice.com What's new in PPT 2010? http://www.echosvoice.com/2010.htm Fixing PowerPoint Annoyances http://tinyurl.com/36grcd PowerPoint 2007 Complete Makeover Kit http://tinyurl.com/32a7nx "Baha" wrote in message ... Using Power point 2007. How can I set the transparency for inserted AutoShape? I have 3 circles that overlay on top of each other. I want the part that overlay them to be about 50% transparent. the transparency shows when they hover over each other but. it is solid when I stop or print it. I can do this in PP 03 but not 07 with pivoted edges. Thanks |
Thread Tools | |
Display Modes | |
|
|