If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
#VALUE! in cells when I open spreadsheet
I have a spreadsheet with links to other excel files. (All excel 2003). When
I open the spreadsheet, the cells all show #VALUE! until I open the other spreadsheets that the links refer to. Is there any to fix this so that the updates work without opening the other spreadsheets. Thank you advance. Tim |
#2
|
|||
|
|||
#VALUE! in cells when I open spreadsheet
Jim Rech posted a registry tweak:
http://groups.google.com/groups?thre...GP11.phx .gbl Tim Chapman wrote: I have a spreadsheet with links to other excel files. (All excel 2003). When I open the spreadsheet, the cells all show #VALUE! until I open the other spreadsheets that the links refer to. Is there any to fix this so that the updates work without opening the other spreadsheets. Thank you advance. Tim -- Dave Peterson |
#3
|
|||
|
|||
#VALUE! in cells when I open spreadsheet
Some formulas are too difficult for Excel to evaluate without opening
the source workbook. (SUMIF is often cited). One solution that sometimes works is to open the sources so that all formulas give correct results then save the workbook and exit. On re-opening the workbook (without the source workbooks being open, errors will sometimes disappear). The reason would be that it was last saved by a previous version of Excel; on opening again in the later version a full recalculation is performed and some formulas are then found to be too hard to compute without fully opening the source workbooks. Bill Manville MVP - Microsoft Excel, Oxford, England No email replies please - respond to newsgroup |
Thread Tools | |
Display Modes | |
|
|