If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Subform view - design view
I have wondered why this happens for a while.
I open my main form in design view one time and the subform opens (like the Main form) in design view like expected. The next time I go into the main form in design view the subform is one big white block and I have to actually open it (double click on it) to open it. Then it opens outside of the main form. Any reason as to what I am doing that one time it the subform in design view the next I actually have to open it up. -- Message posted via http://www.accessmonster.com |
#2
|
|||
|
|||
Subform view - design view
I also see this, i don't think it's a problem just a result of were the form
is opened from - closed to open OR design to Open. I could be wrong though. Is anybody sure of this ? -- Message posted via http://www.accessmonster.com |
Thread Tools | |
Display Modes | |
|
|