If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"un-uniting" a shape
Is there a method to "un-unite" a shape. Once I've united a couple shapes I
can not seem to un-unite them without using Edit-undo. Thanks, |
#2
|
|||
|
|||
"un-uniting" a shape
That is correct, because you are actually creating a single shape from the
union of others, and then they are deleted. If you want it to be reversible later, then you have to use the Group command "Mike Walter" mike.walter-nospam-at.handera.com wrote in message ... Is there a method to "un-unite" a shape. Once I've united a couple shapes I can not seem to un-unite them without using Edit-undo. Thanks, |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shape protection and/or layer properties prevent the complete exec | mryuck | Visio | 0 | July 16th, 2004 08:01 PM |
Going to specific shape on a page when double clicking | Mike Wilcox | Visio | 3 | June 30th, 2004 11:15 AM |
Link a shape so only one copy need be updated | R Fewing | Visio | 2 | June 18th, 2004 09:19 AM |
Stencil Shape Description | Kent Klingler | Visio | 1 | May 21st, 2004 07:37 AM |
Shape references to shapes on different pages | Mark K | Visio | 1 | May 15th, 2004 04:00 AM |