If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
custom check size
I have a form that prints checks from a epson lq-570 dot matrix printer.
When an old dos clarion program is used the checks print and stop at tear off ready for next check to be printed. Under Access the printer prints all that it needs to on the check but continues moving and does not stop at tear off. The check size is 8.5" from left to right edge to edge and 7" from top edge to bottom edge. I have tried margins at 0 for bottom and .25 at top without any success. I do not see that the form page setup has a custom size to it. Thank you for your suggestions. |
Thread Tools | |
Display Modes | |
|
|