If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Adding a letter "m" after a calculated number to indicate length
I have a table with multiple fields including "Length"
Ive created a query to calculate the total of lengths according to the project id. However I was hoping that I could get an "m" after the calculated length so it will show up in a report as "1548m" for example. Thanks for any help! |
Thread Tools | |
Display Modes | |
|
|