|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 5th, 2004, 04:17 PM
|
|||
|
|||
shape opens up massive!
Hi, I am using Visio Pro 2003 and have been for some time now. I am producing a floor plan. When I drag a straight staircase from my shapes onto the document it loads up massively (larger than the page). All my other shapes load up in the correct proportions. Any ideas why would be most appreciated. Cheers Lenny 
|
|
#2
October 6th, 2004, 02:58 AM
|
|||
|
|||
|
Some of the shapes are designed to be used on scaled drawings. Does your
drawing page have a scale? John... Visio MVP Need stencils or ideas? http://www.mvps.org/visio/3rdparty.htm Need VBA examples? http://www.mvps.org/visio/VBA.htm Common Visio Questions http://www.mvps.org/visio/common_questions.htm "lenny" wrote in message ... Hi, I am using Visio Pro 2003 and have been for some time now. I am producing a floor plan. When I drag a straight staircase from my shapes onto the document it loads up massively (larger than the page). All my other shapes load up in the correct proportions. Any ideas why would be most appreciated. Cheers Lenny
|
|
#3
October 6th, 2004, 09:44 AM
|
|||
|
|||
|
The funny thing is that I have started a new floor plan with the same
settings as the other 50 that I have already produced with no problems. "John Marshall, MVP" wrote in message ... Some of the shapes are designed to be used on scaled drawings. Does your drawing page have a scale? John... Visio MVP Need stencils or ideas? http://www.mvps.org/visio/3rdparty.htm Need VBA examples? http://www.mvps.org/visio/VBA.htm Common Visio Questions http://www.mvps.org/visio/common_questions.htm "lenny" wrote in message ... Hi, I am using Visio Pro 2003 and have been for some time now. I am producing a floor plan. When I drag a straight staircase from my shapes onto the document it loads up massively (larger than the page). All my other shapes load up in the correct proportions. Any ideas why would be most appreciated. Cheers Lenny
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Excel opens Maximized, but Workbook opens minimized in Excel Scre. | kselig | General Discussion | 1 | October 8th, 2004 11:26 PM |
| How can I have Visio shape custom property appear in the shape? | Michael J. O'Connell | Visio | 2 | September 28th, 2004 10:45 PM |
| Stencil Shape Description | Kent Klingler | Visio | 1 | May 21st, 2004 07:37 AM |
| Shape references to shapes on different pages | Mark K | Visio | 1 | May 15th, 2004 04:00 AM |
Linear Mode
