If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
NEW data source - reverse engineering
When I step through the Reverse Engineering Wizard and create a new data
source, it doesn't show up in the list. I successfully did it twice before (i don't know if i did something different, I don't think so) but now I cannot get it in the list. When I test the connection at the end of the wizard it says it worked, but it's never in the list. Please help - thanks! mgm |
#2
|
|||
|
|||
I was able to make it work... I never know what type of data source to choose
on the first list (either File based, user, or system). It seems whenever I chose file it never shows up in the list. So - don't waste your time on my question people! "mgm" wrote: When I step through the Reverse Engineering Wizard and create a new data source, it doesn't show up in the list. I successfully did it twice before (i don't know if i did something different, I don't think so) but now I cannot get it in the list. When I test the connection at the end of the wizard it says it worked, but it's never in the list. Please help - thanks! mgm |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is this possible with Excel Chart? | q582gmzhi | Charts and Charting | 1 | September 8th, 2004 03:33 AM |
data labels not linked to data source | viveleroi0 | Charts and Charting | 8 | August 19th, 2004 02:12 AM |
Charts which automatically adapt to variable source data length | Excel Engineer | Charts and Charting | 1 | August 15th, 2004 12:47 PM |
How to create graphs in a monthly report where the base data can change | John Clarke | Charts and Charting | 3 | June 25th, 2004 02:22 AM |
Relink to new data source | Syd | Worksheet Functions | 0 | December 15th, 2003 09:00 PM |