If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I change the unit of measurement on a ruler in Access 2003.
I have been trying to change the unit of measurement from inches to cm on the
ruler in Access 2003 and have been unable to do it. All the dialog and property boxes display as inches and I want them to show as cm but cant find where to make this change. |
#2
|
|||
|
|||
Access uses the unit of measurement you defined in the Windows Control
Panel, under Regional Options. -- Allen Browne - Microsoft MVP. Perth, Western Australia. Tips for Access users - http://allenbrowne.com/tips.html Reply to group, rather than allenbrowne at mvps dot org. "embee29" wrote in message ... I have been trying to change the unit of measurement from inches to cm on the ruler in Access 2003 and have been unable to do it. All the dialog and property boxes display as inches and I want them to show as cm but cant find where to make this change. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TIF images in Access 2003 | Chris | New Users | 1 | June 24th, 2004 04:41 AM |
Access 2003 | RK | General Discussion | 12 | June 14th, 2004 10:16 AM |
Continual Error 1321 Trying to Install Office 2003 | Chad Harris | General Discussions | 9 | June 11th, 2004 08:19 AM |
Access 97 to Access 2003 | Jim Sloan | General Discussion | 3 | June 10th, 2004 10:32 PM |
Two versions again-language issue | Otto | Setup, Installing & Configuration | 3 | May 28th, 2004 04:57 AM |