If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Line Caps
Is there a ways to change the default end cap to square, instead of rounded
and have it stay that way each time I open up Visio? Thanks |
#2
|
|||
|
|||
Line Caps
This setting varies by document, so you can only change the default for
subsequent use in the same document. The default is changed by setting the end cap format when there is no selection in the diagram. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Ken" wrote in message ... Is there a ways to change the default end cap to square, instead of rounded and have it stay that way each time I open up Visio? Thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Line Numbering... (Cannot GoTo)!? | Jeffrey A. Voigt | Page Layout | 0 | July 30th, 2004 07:24 PM |
Discontinue part of line in chart | Jon Peltier | Charts and Charting | 0 | April 1st, 2004 10:27 PM |
How to use (and move) a vertical line as a cursor in x-y plot | Rick Jones | Charts and Charting | 1 | November 3rd, 2003 05:52 PM |