|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 12th, 2004, 12:27 PM
|
|||
|
|||
Visio and word - Geometric Dimension symbols
Afternoon everybody,
Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay 
|
|
#2
August 12th, 2004, 01:17 PM
|
|||
|
|||
|
Visio and word - Geometric Dimension symbols
Ajay,
Are you "Applied" on the North Coast? Dennis -----Original Message----- Afternoon everybody, Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay .
|
|
#3
August 12th, 2004, 01:47 PM
|
|||
|
|||
|
Visio and word - Geometric Dimension symbols
Not as far as I am aware
"Dennis" wrote: Ajay, Are you "Applied" on the North Coast? Dennis -----Original Message----- Afternoon everybody, Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay .
|
|
#4
August 12th, 2004, 02:28 PM
|
|||
|
|||
|
Visio and word - Geometric Dimension symbols
I know an "Ajay" from the Cleveland area.
Just wondered. You could create your own "personal" Visio file of symbols. Open it with your work file and Copy/Paste symbols as needed. -----Original Message----- Not as far as I am aware "Dennis" wrote: Ajay, Are you "Applied" on the North Coast? Dennis -----Original Message----- Afternoon everybody, Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay . .
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Visio in Word or Excel | MPG | Visio | 7 | October 16th, 2004 12:53 AM |
| Importing Visio files to Word | Kevin | Visio | 2 | August 19th, 2004 12:37 AM |
| Visio files in Word | Beth | General Discussion | 0 | May 31st, 2004 12:36 PM |
| Embed linked Visio Obj into Word, rotate 90 degrees | Ganeth | Visio | 0 | May 31st, 2004 07:36 AM |
| How do I convert Visio to Word? | Veeraj Arasa | Visio | 0 | May 2nd, 2004 11:01 PM |
Linear Mode
