If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Visio and word - Geometric Dimension symbols
Afternoon everybody,
Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay |
#2
|
|||
|
|||
Visio and word - Geometric Dimension symbols
Ajay,
Are you "Applied" on the North Coast? Dennis -----Original Message----- Afternoon everybody, Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay . |
#3
|
|||
|
|||
Visio and word - Geometric Dimension symbols
Not as far as I am aware
"Dennis" wrote: Ajay, Are you "Applied" on the North Coast? Dennis -----Original Message----- Afternoon everybody, Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay . |
#4
|
|||
|
|||
Visio and word - Geometric Dimension symbols
I know an "Ajay" from the Cleveland area.
Just wondered. You could create your own "personal" Visio file of symbols. Open it with your work file and Copy/Paste symbols as needed. -----Original Message----- Not as far as I am aware "Dennis" wrote: Ajay, Are you "Applied" on the North Coast? Dennis -----Original Message----- Afternoon everybody, Very new to Visio!! Is it possible to create a template with different drawings on in visio which I can open up when needed. Have all the different designs/ symbols in one place? I have to add geometric tolerance symbols to a engineering report in word. TIA Ajay . . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Using Visio in Word or Excel | MPG | Visio | 7 | October 16th, 2004 12:53 AM |
Importing Visio files to Word | Kevin | Visio | 2 | August 19th, 2004 12:37 AM |
Visio files in Word | Beth | General Discussion | 0 | May 31st, 2004 12:36 PM |
Embed linked Visio Obj into Word, rotate 90 degrees | Ganeth | Visio | 0 | May 31st, 2004 07:36 AM |
How do I convert Visio to Word? | Veeraj Arasa | Visio | 0 | May 2nd, 2004 11:01 PM |