If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Best way to get a border around text on connector
Hi,
I may be missing something simple, but is it possible in Vision 2003 to apply a border to the text block that's part of a connector? As a workaround, I tried adding a rectangle, moving it on top of the connector, and grouping the two. However, when I then moved a shape connected to the connector, the rectangle with my text did not move along with the connector. Any thoughts greatly appreciated. /randy souza |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Vertical text | Geoff Taylor | Setting Up & Running Reports | 4 | August 10th, 2004 02:19 PM |
Hidden text and paragraph borders | Monique | General Discussion | 9 | July 28th, 2004 03:31 PM |
align text in middle of text box | Barbara White | Formatting Long Documents | 1 | May 19th, 2004 04:33 PM |
Text Box in table woes. :( | JOE | Tables | 10 | May 5th, 2004 01:21 AM |
Extracting text | Nemo | Worksheet Functions | 3 | April 6th, 2004 02:33 PM |