If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Command button wizard won't start
Within the last week when I add a command button to a form the wizrd will not
start. I have changed the registry key for sandbox from 3 to 2. That didn't work. Anyone hav a clue. Was there an update that affected this? Could I not have the right resource in my application? |
#2
|
|||
|
|||
Command button wizard won't start
On the Toolbox toolbar, there is a button that looks like a magician's wand
(second from the left on mine). Make sure this button is selected; it turns the wizard on and off. "Adam" wrote: Within the last week when I add a command button to a form the wizrd will not start. I have changed the registry key for sandbox from 3 to 2. That didn't work. Anyone hav a clue. Was there an update that affected this? Could I not have the right resource in my application? |
#3
|
|||
|
|||
Command button wizard won't start
And here's a visual of what Chris wrote:
http://www.btabdevelopment.com/main/...7/Default.aspx -- Bob Larson Access World Forums Super Moderator Utter Access VIP Tutorials at http://www.btabdevelopment.com If my post was helpful to you, please rate the post. __________________________________ "Adam" wrote: Within the last week when I add a command button to a form the wizrd will not start. I have changed the registry key for sandbox from 3 to 2. That didn't work. Anyone hav a clue. Was there an update that affected this? Could I not have the right resource in my application? |
Thread Tools | |
Display Modes | |
|
|