Outline Numbering

I produce procedures using outlined numbered lists using three levels of promotion i.e. 1.0, 1.1, 1.1.1. The procedure carrys through the preamble about the procedure for a couple of pages which is OK. It then, on a new page, returns to item 4.0, where the numbering is expanded to the three levels. My problem is - although told to revert back to 4.0, the numbered list on the previous pages also renumber, or, the list refuses to start at 4.0 and carries on numbering as it feels best. Should I be using section breaks?

Make sure you have set up your outline numbering according to the
instructions at
http://www.shaunakelly.com/word/numb...Numbering.html, and it
should be relatively trouble-free.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
Word MVP FAQ site: http://word.mvps.org
Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.

"Ann" wrote in message
...
I produce procedures using outlined numbered lists using three levels of
promotion i.e. 1.0, 1.1, 1.1.1. The procedure carrys through the preamble
about the procedure for a couple of pages which is OK. It then, on a new
page, returns to item 4.0, where the numbering is expanded to the three
levels. My problem is - although told to revert back to 4.0, the numbered
list on the previous pages also renumber, or, the list refuses to start at
4.0 and carries on numbering as it feels best. Should I be using section
breaks?