|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 31st, 2009, 06:57 PM
posted to microsoft.public.word.tables
|
|||
|
|||
Reconnected table doesn't line up
Hello,
I split a table into 2 so that I could add columns to the second half. Once I had the second half as I wanted it (keeping the overall table the same width before splitting it), I deleted the space in between the tables to reconnect them. However, when it merges back into one table, the 2nd section is indented. All of the table settings are the same: same table style, same width, both are centered on the page, etc. I tried dragging the left-most borders to match back up but that doesn't work either. Please help. I've done this hundreds of times with other tables with no issues. thanks Jen 
|
|
#2
September 5th, 2009, 04:14 PM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Reconnected table doesn't line up
Try setting the table alignments to left before you merge them.
Pam jen_writer wrote: Hello, I split a table into 2 so that I could add columns to the second half. Once I had the second half as I wanted it (keeping the overall table the same width before splitting it), I deleted the space in between the tables to reconnect them. However, when it merges back into one table, the 2nd section is indented. All of the table settings are the same: same table style, same width, both are centered on the page, etc. I tried dragging the left-most borders to match back up but that doesn't work either. Please help. I've done this hundreds of times with other tables with no issues. thanks Jen -- Message posted via OfficeKB.com http://www.officekb.com/Uwe/Forums.a...ables/200909/1
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
