If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
endnotes into a table without losing numbering
I have a large number of endnotes which I want to reformat
so that I can two or three entries to a line. One way to do this I thought was to create a table with three columns and paste the endnotes into these columns. However, when I do this all the numbering in the endnotes is set to 1. Any ideas of a solution? Thanks, Charles. |
#2
|
|||
|
|||
endnotes into a table without losing numbering
Hi Charles
At the end of your document (but before the endnotes) use Insert Break to insert a section break. Now, Format Columns. Hope this helps. Shauna Kelly. Microsoft MVP. http://www.shaunakelly.com/word "Charles" wrote in message ... I have a large number of endnotes which I want to reformat so that I can two or three entries to a line. One way to do this I thought was to create a table with three columns and paste the endnotes into these columns. However, when I do this all the numbering in the endnotes is set to 1. Any ideas of a solution? Thanks, Charles. |
Thread Tools | |
Display Modes | |
|
|