If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Formatting a line on one data-series
I have a simple line graph that has 6 data points. 3 of
those points are based off actual numbers and the other 3 are projected numbers. I would like my one line to be solid where the numbers are factual and dotted where the numbers are projected. When I go to "Format Data Series" and change the style of the line, it changes the entire line. How can I just change particular segments so that half of my line is solid and the other half is dotted? Thanks! -JF |
#2
|
|||
|
|||
Formatting a line on one data-series
You have to select the series itself. Where the projected numbers begin,
select the line, then click again to just highlight that portion to change the format of the line. You will have to do this for each projected series point. Hope this helps. Rita Palazzi Senior Engineer / FedEx Express "Jeff Franzetti" wrote in message ... I have a simple line graph that has 6 data points. 3 of those points are based off actual numbers and the other 3 are projected numbers. I would like my one line to be solid where the numbers are factual and dotted where the numbers are projected. When I go to "Format Data Series" and change the style of the line, it changes the entire line. How can I just change particular segments so that half of my line is solid and the other half is dotted? Thanks! -JF |
Thread Tools | |
Display Modes | |
|
|