If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
memo entry
Any suggestions appreciated
I have a field in a document management database that will show countries and towns refered to in various single documents. I am therefore, intending to put numerous entries in a single box(EG paris, london, frankfurt, new york, dublin, los angeles etc etc)Some of these documents refere to hundreds of cities and towns. I would like the entries in the box to scroll benieth one another with a scroll bar. rather than run along the box, out of sight. can this be done? or is there another way of doing it completely? |
#2
|
|||
|
|||
Am looking back to older posts, so not sure if you're
still looking for ideas. Don't think what you want can be done in table view, but it can be done in form view. Separate each city name with Ctrl+Enter. This starts a new line in the field. The field box will show a scroll bar on the form if there is more data in the field than the box's design height will display, so you can make the box only two or three lines high and "longest city name plus a bit" wide. WATCH OUT, though... If you later want to use this field in a report, you'll have big display problems if the list gets more than a few cities long. Think ahead on this idea - you may create more problems than you want. Hope this helps -----Original Message----- Any suggestions appreciated I have a field in a document management database that will show countries and towns refered to in various single documents. I am therefore, intending to put numerous entries in a single box(EG paris, london, frankfurt, new york, dublin, los angeles etc etc)Some of these documents refere to hundreds of cities and towns. I would like the entries in the box to scroll benieth one another with a scroll bar. rather than run along the box, out of sight. can this be done? or is there another way of doing it completely? . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
QDE (Quick Date Entry) | Norman Harker | Worksheet Functions | 37 | September 5th, 2004 01:24 AM |
Memo Field data truncated in query | Joel | Running & Setting Up Queries | 3 | August 4th, 2004 03:40 PM |
Powerpoint97 - Automate EMail | Simon | Powerpoint | 5 | July 28th, 2004 05:46 PM |
decipher log of scanpst.exe | km | General Discussion | 0 | July 18th, 2004 09:00 AM |