If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Using ConvertToText to create tables containing cells with embedde
Hi mystery man,
You probably could wait until you have created the table, and only then change \n into paragraph marks. I guess currently \n is changed into vbCr in the function .ToString? You could either take the conversion of "\n" out of that function, or, if you don't want to change it because it's used elsewhere, immediately replace vbCr back into some placeholder ("\n" or whatever). Regards, Klaus |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create tables from form etc | [email protected] | Using Forms | 11 | July 5th, 2004 11:35 PM |
Tables used during development | rpw | New Users | 6 | July 1st, 2004 01:29 AM |
Treatment of blank cells in chart driven by a combo box | K. Georgiadis | Charts and Charting | 4 | May 24th, 2004 03:48 AM |
Automating changes in order of columns and/or stacks | Leslie | Charts and Charting | 13 | May 22nd, 2004 09:00 AM |
How do I create a chart using cells from multiple worksheets? | Paul | Charts and Charting | 1 | December 23rd, 2003 05:32 PM |