If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Shapes - Bring to front
Sometimes when I print preview I find that shapes have moved back - behind
others. Any ideas as to what I may be doing wrong? |
#2
|
|||
|
|||
Shapes - Bring to front
On Mon, 15 Sep 2008 19:10:30 +0100, "John"
wrote: Sometimes when I print preview I find that shapes have moved back - behind others. Any ideas as to what I may be doing wrong? Are you sure they have moved back and that they are not just on a non-printing layer? -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
#3
|
|||
|
|||
Shapes - Bring to front
"Paul Herber" wrote in message ell.net... On Mon, 15 Sep 2008 19:10:30 +0100, "John" wrote: Sometimes when I print preview I find that shapes have moved back - behind others. Any ideas as to what I may be doing wrong? Are you sure they have moved back and that they are not just on a non-printing layer? -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ I have been doing some building plans - different aspects on different layers. Sometimes I make features visible / printable - and other times not. The order seems to change. Can I fix it somehow? |
#4
|
|||
|
|||
Shapes - Bring to front
On Tue, 16 Sep 2008 16:53:42 +0100, "John"
wrote: "Paul Herber" wrote in message well.net... On Mon, 15 Sep 2008 19:10:30 +0100, "John" wrote: Sometimes when I print preview I find that shapes have moved back - behind others. Any ideas as to what I may be doing wrong? Are you sure they have moved back and that they are not just on a non-printing layer? I have been doing some building plans - different aspects on different layers. Sometimes I make features visible / printable - and other times not. The order seems to change. Can I fix it somehow? Well, if it's now layers being switched off then offhand I can't think of anything that might cause this. You could email me the document and I'll have a quick look. paul at pherber dot com -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/ |
#5
|
|||
|
|||
Shapes - Bring to front
"Paul Herber" wrote in message ell.net... On Tue, 16 Sep 2008 16:53:42 +0100, "John" wrote: "Paul Herber" wrote in message dwell.net... On Mon, 15 Sep 2008 19:10:30 +0100, "John" wrote: Sometimes when I print preview I find that shapes have moved back - behind others. Any ideas as to what I may be doing wrong? Are you sure they have moved back and that they are not just on a non-printing layer? I have been doing some building plans - different aspects on different layers. Sometimes I make features visible / printable - and other times not. The order seems to change. Can I fix it somehow? Well, if it's now layers being switched off then offhand I can't think of anything that might cause this. You could email me the document and I'll have a quick look. paul at pherber dot com -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/ Files are too big - I will try to rationalise the problem better. |
Thread Tools | |
Display Modes | |
|
|