If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Visio2003 - How do I get a 3 segment straight line connector?
I'm trying to diagram a series of connections and would like to use a 3 sided
connector - the default is 2 sided or curved. Unlike Illustrator, I cannot seem to find any way to insert an additional vertices. Any ideas (other than connecting a line and a connector visually)? |
#2
|
|||
|
|||
Under File Shapes Visio Extras Connectors you can find some specialty
connectors shapes. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "emck" wrote in message ... I'm trying to diagram a series of connections and would like to use a 3 sided connector - the default is 2 sided or curved. Unlike Illustrator, I cannot seem to find any way to insert an additional vertices. Any ideas (other than connecting a line and a connector visually)? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Discontinue part of line in chart | Jon Peltier | Charts and Charting | 0 | April 1st, 2004 10:27 PM |
How to use (and move) a vertical line as a cursor in x-y plot | Rick Jones | Charts and Charting | 1 | November 3rd, 2003 05:52 PM |